You are currently viewing Where to Position a Campervan Water Filler

Where to Position a Campervan Water Filler

A campervan water filler should be easy to reach at a campsite and easy to inspect from inside the van. Pick the position while you can still see both sides of the panel. A neat cap on the outside can hide an awkward hose bend behind a drawer or an unreachable joint at the top of the tank.

Choose how you want to fill the tank

Compare a fixed outside filler with removing a portable container and filling it separately. Look at your usual distance to the tap and how you will know when to stop filling. A fixed system needs a compatible inlet, pipe and venting arrangement. Keep any drinking-water filling equipment suitable for that use and store it separately from anything used for waste water.

Follow the hose route on the inside

Mark the filler and tank inlet from two fixed points and draw the route on the cabinet plan. Follow the component maker’s directions on hose and vent runs and check that you can reach the clamps later. Before making any body opening, check the vehicle guidance and inspect both sides for structure, cables and nearby equipment. Ask a suitable installer if the location is uncertain.

Test with the van supported normally

With the furniture still open, use a drinking-water supply and check the joints while filling slowly. Look for pinched hose, spitting at the inlet and water leaking behind the trim. Use the system instructions to understand overflow behaviour and normal filling limits. Write down which removable panel gives access, so the next inspection takes minutes.

FAQ

Should I put the filler next to the sliding door?

Check whether the slider or handles obstruct it and what the hose route looks like inside. Choose a spot you can still reach with your usual camping setup.

Can the filler and tank use the same hose as grey water?

Keep filling equipment dedicated to drinking water and use suitable components for its intended supply.

Read our guide to planning the fresh-water tank for the next part of the build. You can also send your layout and measurements to NEVAN.