You are currently viewing Choosing a Position for a Campervan Shore Power Inlet

Choosing a Position for a Campervan Shore Power Inlet

A campervan shore power inlet becomes part of your arrival routine at every pitch with hook-up. Choose its position with the lead, slider and awning in mind. Then check what lies immediately behind the outer panel, where the connection must remain accessible for a qualified installer.

Test where you can reach the inlet while parked

Mark a proposed position on the van and hold an unplugged lead near it. Try the side door both ways and check a typical route towards the site bollard. Choose an arrangement suited to water exposure, clear of doors, steps and places where someone is likely to trip. Follow the vehicle and inlet instructions before making any body opening.

Include the inside service route

Plot the inlet body and rear clearance on the furniture drawing. Keep it clear of wet storage and give the electrician an accessible route to inspect the fixed installation. The Camping and Caravanning Club guide to campsite electricity explains responsibilities for the lead, supply and vehicle electrical equipment. Have the vehicle mains installation fitted and checked by a qualified technician with relevant experience.

FAQ

Does any weatherproof connector suit shore power?

Use equipment suitable for the actual vehicle mains installation and have the connection and protection specified by the installer.

Should the inlet sit inside the awning?

Walk the proposed cable path with the awning and step in place. Keep access safe and follow all product and campsite instructions.

Read our campervan hook-up and campsite power guide for the next part of the build. You can also send your layout and measurements to NEVAN.