A campervan shower curtain works best when it falls inside the tray all the way around the wet area. In a small cubicle, a slight change in track position can make the curtain brush your shoulder or drip behind the threshold. Try a temporary sheet while standing in the shower before choosing the rail.
Mark where the curtain needs to hang
Draw the edge of the tray and mark where the track will sit in relation to it. Include the rail carriers and finished curtain hem. Try opening the door with the temporary curtain in place. If the corner curves, test a sample of the track to see whether the carriers pass easily around it. Keep the usual exit path free when the curtain is open.
Select hardware for the wet area
Choose a curtain and fittings intended for the location. Check how the track will be supported and whether a fixing passes through a waterproof part of the enclosure. Follow the panel and track maker’s guidance for fixings and seals. Choose a way to remove the curtain to clean or dry it, and check the product instructions for any lower weights or attachments.
Make room to dry it after use
Check where water from a folded curtain will drip. Leave it spread over the tray to dry where practical, with ventilation appropriate to the setup. If you take it down wet, give it a dedicated place to dry before packing it into a cupboard. Try stepping out of the tray with a towel in the same space you will have on a trip.
FAQ
How long should the curtain be?
Measure from the finished track hardware to where the hem needs to fall within the tray. Leave enough room to keep the fabric clear of standing water.
Can I fit a track to the van ceiling lining alone?
Check the track maker’s fixing instructions and the lining structure. Light trim may need backing to carry the track and the repeated pull of the curtain.
Read our campervan shower panel guide for the next part of the build. You can also send your layout and measurements to NEVAN.