You are currently viewing Planning a Campervan Bed Extension

Planning a Campervan Bed Extension

A campervan bed extension can add room for feet without taking up the full aisle during the day. Work out how much usable length is missing at mattress height. A short extra deck may solve the problem if the real restriction is a cupboard or the angle of the rear door above the feet.

Measure the extra sleeping length you need

Lie on the intended mattress and mark where your heels and bedding reach. A nominal six-foot deck can feel shorter once the van wall curves in or a cushion takes up the end. Test a temporary foam infill on a safe, supported frame. Then mark where the extension lands with the main bed in its usual position.

Decide how the extra deck will be supported

A sliding section, folding leaf or removable bridge all need a suitable load path and positive location during use. Ask the designer or supplier to check span, materials and fasteners. Try the assembly on the plan with the planned mattress thickness, open garage doors and the nearby drawers. Work out how the panels or legs will be held during travel.

Run through the evening setup

Put the bedding, pillows and water bottles where they normally live. Check whether the extension blocks your way to the door or toilet, and whether you can make the bed from one side. Look at how any cushion join falls relative to your heels or calves. Once the support is fitted, inspect its movement and clearances as its designer recommends.

FAQ

Would a thicker mattress make an extension easier?

Mattress thickness can hide a small change in height but cannot replace a correctly supported, level deck. Check both surfaces together.

Where should a removable panel go in the day?

Choose a dedicated secure slot you can reach without unpacking the garage. Test it with the van carrying its usual gear.

Read our campervan bed frame guide for the next part of the build. You can also send your layout and measurements to NEVAN.